Increasing the refresh rate within the supported range may reduce the flicker on your screen. Change the refresh rate of your monitor via the graphics card setting page in your operating system. Please visit to contact our technical support for assistance. What is the reason of this? Check the pin connector of your monitor video cable, verify that there are no damaged or bent pins, if everything looks fine then this would indicate a possible fault within the monitor. Also use the maximum refresh rate your monitor is capable of at the resolution your are using. Move electrical devices that may cause electrical interference as far away from the monitor as possible. Also make sure that all the pins of the monitor's video cable are in good condition. You need to plug the monitor's video cable directly to the video card connector on the back of your computer to obtain the best picture quality from the monitor. These problems are caused by using an extension video cable or switch box. Then if there is still no display, this typically indicates that the monitor is not receiving a video signal from the video card in your computer. What is the reason of this? Check to see that the computer is not on power-saving mode by pressing any key or moving the mouse. What is the reason of this? This indicates a possible fault with the monitor. Adjust H-Position and V-Position or press hot-key AUTO. Adjust RGB color or select desired color temperature. Plug the USB-C cable into your computer and give it a few moments to let your system detect and recognize the monitor. Follow the prompts on the DisplayLink Installer and Reboot if prompted to. Open and Run the file from the saved location or download link 8. Select the folder where you want to download the file to on your computer 7. Make sure the USB Monitor is disconnected from the computer. If you do find any issues during installation, please contact Apple technical support. Your monitor is Plug and Play with the Mac OS operating system. The system will automatically select the maximum refresh rate and corresponding Color Matching Profiles. Close all open windows and remove the CD. The files will be copied from the CD to your hard disk drive. Right click and click All apps at the bottom-right of the screen. Click on the 'Start' button and then click on 'Control Panel'.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |